Expanded Procedures
03-300529 Issue 4 January 2008 95
Enable RAM disk
The following steps enable RAM disk on the server:
1. Access the server’s command line interface using an SSH client, like PuTTY, and the
192.11.13.6 IP address.
2. At the command line type sudo ramdisk -v -f disabled and press Enter.
The system does not display any information to the screen if there are no errors.
3. At the command line type ramdisk -v -s and press Enter.
Confirm that the output is ramdisk: DisklessOperation entry in ecs.conf contains the
value disabled and the actual state of the server is enabled."
4. Reboot the server.
To Next Page
Loading...
