Replacing the hard drive in the S8500 server
03-300529 Issue 4 January 2008 85
Replacing the hard drive in the S8500 server
Depending on the S8500 server model, select one of the following procedures:
l Replacing the hard drive in the S8500C server
l Replacing the hard drive in the S8500B server
l Replacing the hard drive in the S8500 server
!
CAUTION:
CAUTION: Wear an antistatic wrist ground strap whenever handling components such as the
hard drive of an Avaya S8500 server. Connect the strap to an approved ground,
such as an unpainted metal surface. Also, place the hard drive on an antistatic
mat that is similarly grounded. Do not place the new or the old drive on a bare
surface.
Replacing the hard drive in the S8500C server
This procedure contains the following sections:
l Removing the hard drive from the S8500C server
l Installing the replacement drive in the S8500C server
Removing the hard drive from the S8500C server
To remove the hard drive from the S8500C server:
1. Reach inside the hard drive bay on the front panel of the S8500C server and grab the two
"D" loops of the dual-loop carrier (see Figure 17: Removing/replacing the hard drive on the
S8500C server on page 86).
To Next Page
Loading...
