Replacing the S8500C server
03-300529 Issue 4 January 2008 59
Note:
Note: You do not need to fill in the static routes for Release 2.0 and later.
5. When you click through all the pages, click Continue on the Update System screen. The
Update System screen displays each configuration task as it completes.
When done, the screen displays “All configuration information was entered.”
6. Click Close Window to close the Configure Server wizard.
7. If this server is a LSP or an ESS, issue these commands from the server command line:
a. stop -af or stop -caf to stop the LSP/ESS
b. start -a or start -ca to start the LSP/ESS
Replacing the S8500C server
When replacing a failed S8500C server, you can re-use these components:
l Hard drive
l Server Availability Management Processor (SAMP)
l Network interface card (NIC)
If these components are serviceable, we recommend that you remove them from the failed
server and install them in the replacement server. For specific information see:
l Reusing the hard drive (S8500C) on page 61
l Reusing the SAMP (S8500C) on page 64
l Reusing the dual NIC (S8500C) on page 66
Powering down and disconnecting the S8500C server
To power down the S8500C server:
!
CAUTION:
CAUTION: Do not unplug a functioning server without stopping all processes first. Failure to
do this will corrupt the hard drive.
1. If the server is functional, type stop -h -f on the command line or use the Web page to
shut down the server.
If this does not work, press the power button to shut off the server.
To Next Page
Loading...
