Avaya S8500 Series - Enable RAM Disk; Verifying the S8500 C Server Configuration

Replacing the S8500C server
03-300529 Issue 4 January 2008 75
Enable RAM disk
You must enable RAM disk and reboot the server:
1. Access the server’s command line interface using an SSH client, like PuTTY, and the
192.11.13.6 IP address.
2. At the command line type sudo ramdisk -v -f enabled and press Enter.
The system does not display any information to the screen if there are no errors.
3. At the command line type ramdisk -v -s and press Enter.
Confirm that the output is ramdisk: DisklessOperation entry in ecs.conf contains the
value enabled and the actual state of the server is disabled."
4. Reboot the server.
Verifying the S8500C server configuration
The following steps verify the replacement S8500C server configuration.
1. Under Server Configuration, click Configure Server to start the configure server process.
2. Click Continue through the Review Notices to get to the Select Method for Configuring
Server page.
3. Select Configure all services using the wizard.
4. Click Continue through all the screens to verify that the configuration is complete and
correct.
Note:
Note: You might need to reset the port speeds for the Ethernet interfaces.