03-300529 Issue 4 January 2008 181
Connecting the cables to the RSA
To connect the cables to the RSA:
1. Connect the external power supply (Note 2 in Figure 51: RSA faceplate and connectors
on
page 170) to the RSA.
Note:
Note: Do not apply power to the server yet.
2. Connect the modem to the RS-232 port.
3. Do not plug in the LAN connection (if used). You will need to access the Ethernet port on the
RSA once power is restored.
Powering up the server
Complete the following steps if you want to start the server at this time:
1. Plug the power cord in the back of the server.
2. Press the Power Button located on the front on the right hand side.
3. Log into the server to ensure that the startup is complete.
Restoring the RSA configuration
Complete the following steps to restore the RSA configuration information:
1. Connect the services laptop to the Ethernet port on the RSA using a crossover cable.
2. Open a browser window.
3. Type 192.11.13.6 in the address field of the browser, and press Enter.
4. The Enter Network Password window appears.
5. Enter the default login of craft and default password of passw0rd (with a zero).
6. In the RSA welcome screen, select the no timeout value from the drop-down list (see
Figure 59: RSA Welcome screen
on page 182). The no timeout value allows 60 minutes of
use before disconnecting.
To Next Page
Loading...
