Hard drive
03-300529 Issue 4 January 2008 21
Re-using the original hard drive
Using this procedure means that you are re-using the original hard drive.
39 RSA only: Log into the RSA
card
Open a browser on your laptop. Type 192.11.13.6 and
press Enter to log into the RSA.
Note: Use the initial installation craft login and the initial
RSA password.
40 RSA only: Set a timeout
value
On the RSA welcome screen, on the Inactive session
timeout value field, select no timeout and click
Continue. This allows 60 minutes of inactivity before
disconnecting.
41 RSA only: Set the loader
watchdog timeout
Under ASM Control, click System Settings. Scroll down
to the Server Timeouts section, and in the Loader
watchdog field, select 5.0 (minutes) and click Save.
42 RSA only: Log off and
disconnect from the RSA
Click Log Off. Once you are logged off, disconnect from
the services port on the RSA.
Final tasks for replacing an S8500/B/C server using the blank hard drive (continued)
9
Task Description
6 of 6
Final tasks for replacing an S8500/B/C server reusing the
original hard drive
9
Task Description
1 Connect laptop to the
server
Connect to the services port on the back of the server.
2 Log onto the Maintenance
Web Interface
Open a browser on your laptop. Type 192.11.13.6
and press Enter to log onto the Maintenance Web
Interface.
3 Verify date and time Under Server, click Server Date/Time. Make changes
as necessary.
4 Ping the connections on the
server
Under Diagnostics, click Ping. Ensure that all
administered connections respond.
1 of 2
To Next Page
Loading...
