03-300529 Issue 4 January 2008 169
Job Aid: Replacing the Remote Supervisor Adapter
(RSA)
!
Important:
Important: Always check the Avaya Support Website for Product Support Notices at
http://support.avaya.com
and select Product Support Notices (All Avaya
products) in the MOST POPULAR PRODUCTS IN SUPPORT section.
This document contains information and procedures for replacing the Remote Supervisor
Adapter (RSA) board in the Avaya S8500 server. Detailed discussions of these topics follow:
l Backing up the RSA
l Backing up the server
l Powering down the server and RSA
l Removing the cover of the server
l Replacing the ribbon cable
l Removing the adapter support bracket and riser connector
l Installing the new RSA card
l Replacing the cover of the server
l Connecting the cables to the RSA
l Powering up the server
l Restoring the RSA configuration
l Upgrading the RSA firmware
l Checking the RSA installation
l Restoring the RSA defaults
The RSA is factory installed in PCI-X slot 1 of the S8500 server. Figure 51 shows the RSA
faceplate and connectors.
For information about updating RSA firmware, see The Avaya RSA Users’ Guide, 555-245-702.
To Next Page
Loading...
