Avaya S8500 Series - Powering down the Server and RSA

Job Aid: Replacing the Remote Supervisor Adapter (RSA)
176 Job Aids for Field Replacements (FRUs) for the Avaya S8500 Server
Powering down the server and RSA
After the backup is finished, complete the following steps to power down the server and the
RSA.
1. From the server Web interface click Server > Shutdown Server.
2. Select Delayed Shutdown.
3. Click Shutdown.
4. After the server shuts down, unplug the power cord from the back of the server.
5. Unplug the external power supply connection (Note 2 in Figure 51: RSA faceplate and
connectors on page 170) from the RSA.
!
DANGER
:
DANGER: Ensure that all power is removed from the server and the RSA.
6. Disconnect the modem from the RS-232 port on the RSA.
7. Disconnect and label the LAN connection (if used) from the Ethernet port on the RSA.
8. Pull the server forward so that the server rails expand and the retaining clips on the rails
click into place.