03-300529 Issue 4 January 2008 185
Note:
Note: The RSA firmware is loaded into the RSA card as three separate files. So, either
there will be three files on the support site, or the user will download a single file
and split it into the three separate files with WinZip or a similar program.
4. Log into the RSA using the instructions found under the Backing up the RSA
on page 170.
5. In the navigation pane, select Firmware Update.
6. In the Choose File window, click Browse. Go to the saved location from Step 3
.
7. Click on one of the three firmware files and then click Open.
The file name appears in the box next to Browse.
8. Click Update to begin the firmware update.
A progress window opens as the files are transferring to temporary storage on the RSA.
A confirmation window opens when the transfer is complete.
9. Verify that the file in the confirmation window is the file you want to update. If you do not
want to continue click Cancel.
10. To continue with the firmware update click Continue.
A progress window opens as the firmware on the RSA updates. A confirmation window
appears when the update is completed.
11. Repeat Step 6
through Step 9 for the remaining two firmware files.
12. Restart the RSA by clicking on Restart.
13. Click OK to continue.
14. Click OK to close the browser window.
15. Log into the RSA.
Checking the RSA installation
Check the following to ensure that the installation was successful:
1. Under Monitors, System Health ensure that the RSA can read the system health of the
S8500.
If the RSA cannot read the system health of the S8500:
l The RSA may not be seated correctly in the riser card. Follow the instruction starting at
Powering down the server and RSA
on page 176 to reseat the RSA.
l The RSA may be defective.
l The S8500 server may be defective. Contact the TSO for verification and instructions.
l The ribbon cable might not be seated at either or both ends.
To Next Page
Loading...
