Job Aid: Replacing the Avaya S8500 dual network interface
154 Job Aids for Field Replacements (FRUs) for the Avaya S8500 Server
Configuring the NIC
After the S8500/B/C server is back in service, configure the Ethernet interface settings:
1. Go to Server Configuration > Configure Server Web page.
2. Click Continue through the review notices until you get to the Configure Server page with
"Specify how you want to use this wizard" at the top.
3. Select Configure Individual Services and click Continue.
The wizard displays a new left-side navigation panel.
4. Select Set Identities.
The Set Server Identities page displays.
5. Ensure that the Ethernet ports are mapped as they were before replacing the dual network
interface (see Check Ethernet interface settings
on page 140):
To Next Page
Loading...
