Replacing the S8500C server
03-300529 Issue 4 January 2008 73
Disable RAM disk
You must disable RAM disk before restoring translations:
1. Access the server’s command line interface using an SSH client, like PuTTY, and the
192.11.13.6 IP address.
2. At the command line type sudo ramdisk -v -f disabled and press Enter.
The system does not display any information to the screen if there are no errors.
3. At the command line type ramdisk -v -s and press Enter.
Confirm that the output is ramdisk: DisklessOperation entry in ecs.conf contains the
value disabled and the actual state of the server is enabled."
4. Reboot the server.
Restoring the system files (S8500C)
The following steps restore the system files.
1. At the Maintenance Web Interface, under Data Backup/Restore, click View/Restore Data.
2. Select FTP and fill in the User Name, Password, Host Name (must use the host IP
address), and Directory fields where the files were backed up.
To Next Page
Loading...
