Job Aid: Replacing the Avaya S8500 dual network interface
148 Job Aids for Field Replacements (FRUs) for the Avaya S8500 Server
!
CAUTION:
CAUTION: Be sure that the NIC is completely and correctly seated in the PCI-2 expansion
slot of the Avaya S8500C server. Incomplete insertion might cause damage to
the system board or the dual NIC.
2. Replace the PCI-BUS carriage by pressing the assembly into the slot.
3. Continue with Replacing the cover and cabling
on page 151.
Installing the new network interface card in the S8500B server
Note:
Note: Wear an antistatic wrist ground strap whenever handling the server or its
components. Connect the strap to an approved ground, such as an unpainted
metal surface. See the job aid titled Approved Grounds for more information.
To install the network interface card (NIC) in the S8500B server:
1. Carefully grasp the new NIC by the top edge or upper corners and align it with the PCI-BUS
expansion slot on the motherboard. (The SAMP is connected on the other side of this
connector.) Press the NIC firmly into the expansion slot. See Figure 44: Inserting the
network interface card in the S8500B server on page 148.
Figure 44: Inserting the network interface card in the S8500B server
2
1
indsbnic KLC 101404
To Next Page
Loading...
