Avaya S8500 Series - Replacing the Cover on the Replacement S8500 B Server; Installing the Replacement S8500 B Server in the Rack

Replacing the S8500B server
03-300529 Issue 4 January 2008 51
Note:
Note: Be sure that the NIC is completely and correctly seated in the PCI-2 expansion
slot of the Avaya S8500B server. Incomplete insertion might cause damage to
the system board or the NIC.
3. Position the faceplate so that it fits in the PCI-2 slot using the captive screw to hold it in
place.
4. Tighten the captive screw on the back panel.
Replacing the cover on the replacement S8500B server
To replace the cover on the S8500B server (see Figure 7: Removing and replacing the cover
on the S8500B server on page 44 if necessary):
1. Slide the server cover until the cover’s tabs are seated in the top slot on the front panel.
2. Tighten the captive screw on the back of the server that holds the cover in place.
Installing the replacement S8500B server in the rack
The following steps install the replacement S8500B server back in its rack.
1. Install the server onto the slide rails in the rack.
2. Locate the marked cable that you removed from the NIC (if used) and plug it into the NIC.
3. Connect the USB modem cable to the SAMP.
4. Connect the LAN connection (if used) to the Ethernet port on the SAMP.
5. Connect the power cord to the SAMP.
6. Connect the power cord to the back of the server.
7. Push back into place.
See Quick Start for Hardware Installation: Avaya S8500 server for more information on
installing the S8500/B server in the rack and reconnecting all the cables.