Avaya S8500 Series - Removing the S8500 C Server from the Rack; Removing the Cover of the S8500 C Server

Job Aid: Replacing the Avaya S8500/B/C server
60 Job Aids for Field Replacements (FRUs) for the Avaya S8500 Server
!
CAUTION:
CAUTION: Do not hold down the power button for more than a split second. Holding the
button down too long causes a reboot of the server.
2. Label and disconnect the power cord from the back of the server.
3. Label and disconnect the Ethernet cable from the chassis.
4. Label and disconnect the power cord from the SAMP.
5. Label and disconnect the USB modem cable from the USB port on the SAMP.
6. Label and disconnect the LAN connection (if used) from the Ethernet port on the SAMP.
7. Label and disconnect the cable from the Ethernet port on the dual NIC.
Removing the S8500C server from the rack
To remove the S8500C server from the rack:
1. Ensure that all cables are labeled and disconnected from the server.
2. Loosen the two front thumbscrews on the server.
3. Carefully pull the server from the rack.
Removing the cover of the S8500C server
To remove the cover from the S8500C server:
1. Set the server down on a flat surface with an electrostatic mat.
2. Press the release latch on the top left front of the server (see Figure 12
).