03-300529 Issue 4 January 2008 77
Job Aid: Replacing the Hard Drive on the
Avaya S8500 server
!
Important:
Important: Always check the Avaya Support Website for Product Support Notices at
http://support.avaya.com
and select Product Support Notices (All Avaya
products) in the MOST POPULAR PRODUCTS IN SUPPORT section.
This job aid describes the steps required to replace the hard drive on an Avaya S8500, S8500B,
or S8500C server running Avaya Communication Manager software. This job aid should be
used only if a failure has occurred and it is determined that the hard drive should be replaced.
After replacing the hard drive, you must install the software from the CD-ROM that the customer
received from an earlier installation. The software CD-ROM contains the Linux operating
system and the appropriate release of Avaya Communication Manager.
Required equipment
Verify that you have the following equipment and tools on site:
l Replacement hard drive (Material ID 700341365 for S8500B and S8500C)
l Customer’s software CD-ROM
l Ethernet crossover cable to directly connect your laptop to the server
l Flat-head screwdriver
l Cross-point (Phillips) screwdriver
l Electrostatic wrist ground strap and mat
To Next Page
Loading...
