Avaya S8500 Series - Page 86

Job Aid: Replacing the Hard Drive on the Avaya S8500 server
86 Job Aids for Field Replacements (FRUs) for the Avaya S8500 Server
Figure 17: Removing/replacing the hard drive on the S8500C server
2. Pull the two loops toward each other to release the latch.
3. Pull the hard drive straight out of its bay by the loops.
4. Remove the four screws that fasten the hard drive to the dual-loop carrier.
5. Set the dual-loop carrier and four mounting screws aside for re-use later.
Installing the replacement drive in the S8500C server
To install the replacement hard drive in the S8500C server:
1. Position the dual-loop carrier around the replacement hard drive and fasten in place with
four screws.
2. Slide the replacement hard drive into the server (see Figure 17
).
3. Return to Tasks for replacing a hard drive on an S8500 server
on page 79 to continue with
the listed tasks.
Figure notes:
1. Grasp two "D" loops of the dual-loop
carrier and pull together to release latch
3. Mounting screws
2. Pull hard drive straight out of bay
C
D
-
R
W
DVD
h3msd85c LAO 032406
2
1
3