Replacing the hard drive in the S8500 server
03-300529 Issue 4 January 2008 89
Figure 19: Removing and replacing the cover on the S8500 server
Removing the hard drive from the S8500 server
For these steps, see Figure 20: Removing and replacing the drive cage on page 90.
1. Locate the drive cage in the left-hand corner of the front of the server.
2. Use the black pull handles on the ribbon cables to unplug the data connectors from the back
of the CD-ROM and hard drive.
3. Push ribbon cable back out of the way.
4. Unplug the two power connectors from the back of the CD-ROM drive and the hard drive.
You must release the power connector on the CD-ROM drive by gently bending the side
spring clip holding it in place.
5. Loosen the captive screw next to the drive cage.
6. Slide the drive cage toward the back of the server to clear the retaining hooks.
7. Place the drive cage on the antistatic mat.
Figure notes:
1. Captive screws on server holding cover in place
h3mscaps LAO 070103
disc
1
To Next Page
Loading...
