Avaya S8500 Series - Page 90

Job Aid: Replacing the Hard Drive on the Avaya S8500 server
90 Job Aids for Field Replacements (FRUs) for the Avaya S8500 Server
8. Remove the four screws (two on each side) securing the hard drive in the drive cage and
remove the hard drive.
Figure 20: Removing and replacing the drive cage
Installing the new hard drive in the S8500 server
For these steps, see Figure 20.
1. Insert the new hard drive into the drive cage so that the connectors are in the same
direction as the CD-ROM connectors and the screw holes are aligned.
2. Reinsert the 4 screws (2 on each side) to attach the hard drive to the drive cage.
3. Reattach the flat ribbon cable (in 2 places) to the hard drive and CD-ROM drive.
4. Reattach the 2 power cables to the hard drive and CD-ROM drive.
Figure notes:
1. Drive bay housing drive cage
2. Ribbon cable attached to hard drive
3. Cable connected to the CD-ROM
drive
4. Captive screw holding drive cage
5. Tabs
6. Screws holding hard drive in drive cage
7. Hard drive
8. Drive cage
h3msdrv3 KLC 020204
1
2
3
5
6
6
disc
8
7
4
6