AvL Proprietary and Confidential
Content is Subject to Change without Notice Page 42 of 195
Figure 4.3.1.1 - AAQ Advanced Network Settings
Under the advanced network settings, the two customer networks are accessible to allow connection to
system devices that reside on different networks. See chapter 3 on network settings for more details.
If your network setup allows for network devices to use a DHCP & DNS server you may set the ACU
to obtain its network settings through the DHCP & DNS server via the DHCP checkbox.
Using a DHCP server without a DNS server will cause the controller to receive a valid IP address that is
unknown to the user. Whenever the ACU is set to use DHCP make sure that the server is also a DNS
server.
To check the current running network configuration click the refresh button on the left side of the
window. The application will then query the current network settings on the controller and display
them to the user.
To Next Page
Loading...
Need help?
General