Azbil DCP31 - Page 12

x
Chapter 4. WIRING 4-1
4 - 1 Wiring Precautions
4-1
4 - 2 Compensating Lead 4-3
4 - 3 Terminal Connections 4-4
4 - 4 Layout of Terminals and Recommended Lead Draw-out Direction 4-5
4 - 5 Connecting the Ground and Power Supply 4-6
 Power supply 4-6
 Ground 4-6
4 - 6 Wiring of Standard and Add-on Terminal Base 4-7
 Standard terminal layout 4-7
 Add-on terminal layout 4-7
4 - 7 Connecting Inputs (analog inputs) 4-8
 Connecting input 1 4-8
4 - 8 Connecting control outputs (outputs 1, 2) 4-9
 Relay output (0D) 4-9
 Current output (5G) 4-9
 Position-proportional output (2G) 4-10
 Voltage output (6D) 4-10
 Heat/cool output (3D) 4-11
 Heat/cool output (5K) 4-11
4 - 9 Connecting auxiliary outputs (outputs 2, 3) 4-12
 0D, 5G, 6D auxiliary outputs 4-12
 2G, 3D, 5K auxiliary outputs 4-12
4 - 10 Connecting Event Output (relay output) 4-13
4 - 11 Connecting Time Event Output (open-collector) 4-14
4 - 12 Connecting External Switch (RSW) Input 4-15
4 - 13 Connecting for Communications 4-17
 RS-485 interface 4-17
4 - 14 Isolating Inputs and Outputs 4-20
 Control outputs 0D, 5G, 6D, 3D, 5K 4-20
 Control output 2G 4-21