Azbil DCP31 - Insertion;deletion of segments cannot be confirmed by pressing FUNC + ENT in program setup state; Program deletion cannot be confirmed by pressing FUNC + CLR while entering pattern items in program setup state

9-10
Chapter 9. MAINTENANCE & TROUBLESHOOTING

G.Soak items cannot be displayed by repeatedly pressing in
program setup state
Cause Remedy
Programming items are set to “display
OFF”.
Set setup data
C
7 0
setting to 0.

PV start items, cycle items and pattern link items cannot be displayed
by repeatedly pressing in program setup state
Cause Remedy
Programming items are set to “display
OFF”.
Set setup data
C
7 1
setting to 0.

Insertion/deletion of segments cannot be confirmed by pressing
FUNC
+
ENT
in program setup state
Cause Remedy
The program setup cannot be changed. Set program parameter
P
R T C
setting to 0.
The program being set up is being oper-
ated (RUN. HOLD, FAST, END).
Reset the controller.
Not pattern item on programming map Move to pattern item on programming map.
Pattern item of non-set segment on pro-
gramming map
Either move to already set up segment, or set up
segment.

Program deletion cannot be confirmed by pressing
FUNC
+
CLR
while en-
tering pattern items in program setup state
Cause Remedy
The program being set up is being oper-
ated (RUN. HOLD, FAST, END).
Reset the controller.