Azbil DCP31 - Moving Individual Items in the Parameter Setup

7-2
Chapter 7. PARAMETER SETUP
Name
Upper
Display
Remarks
Variable
parameters
P A R A
Event congu-
ration data
E V
This parameter is not displayed when variable parameter
L O C
is 2 or 4
PID parameters
P 1 D
This parameter is not displayed when variable parameter
L O C
is 2 or 4
This parameter is not displayed when constant-value operation data
.O D E
is 1
This parameter is not displayed when setup data
C 1 8
is 1 by 5G output
This parameter is not displayed when setup data
C 4 5
is 1 by 3D output
Setup data
S E T
This parameter is not displayed when variable parameter
L O C
is 1, 2 or 4
Table data
T B L
This parameter is not displayed when variable parameter
L O C
is 2 or 4
Constant-value
operation data
C N S T
This parameter is not displayed when variable parameter
L O C
is 2 or 4

Moving individual items in the parameter setup
Withindividualitems,itemcodesaredisplayedintheupperdisplay
andsettingvaluesaredisplayedinthelowerdisplay.
TheprogramNo.displaygoesout,andtheitemNo.isdisplayedin
thesegmentNo.display.However,notethatthesegmentNo.display
alsogoesoutinthecaseofsetupdata.
Individualitemsarearrangedinamatrixasshownonthefollowing
page,andcanbedisplayedinorderbypressing
, , or
.Thesizeofindividualitemmatricesvariesaccordingtothe
settinggroup.