Azbil DCP31 - Changing Individual Items and How to Return from the Setup State

7-3
Chapter 7. PARAMETER SETUP

Changing individual items and how to return from the setup state
Ifyoupress
ENT
whenanindividualitemisdisplayed,thesetting
valueblinks.Thisstateisreferredtoasthe“settingvalueentry
state.”Inthisstate,pressing
or canincrementordecre-
mentthesettingvaluethatisblinking.Also,pressing
or 
movesthepositionofthedigitthatisblinking.
Ifyoupress
ENT
whenthesettingvalueisatthedesiredvalue,
blinkingstops,thedisplayreturnstoitsnormallylitstate,andthe
newsettingvalueisstoredtointernalmemory.
Tocancelchangingofsettingvalues,press
PARA
or
DISP
.When
PARA

ispressed,thevaluestopsblinkingandthedisplayreturnstoits
normallitstate.
Ifyoupress
DISP
,thedisplayreturnstothebasicdisplaystate.If
“----”isdisplayedatthelowerdisplaywhenanindividualitemis
displayed,orthecontrollerdoesnotenterthesettingvalueentry
statebypressing
ENT
,thatitemcannotbesetnorchanged.
• Exampleofindividualitemmatrix(setupdate)
C0 1
C02
C03
C0 1
C02
C03
C 11
C 12
C 13
C8 1
C82
C83
C9 1
C92
C93
C9 1
C92
C93
C99
C00
C09
C10
C 19
C20
C89
C90
C99
C00
C0 1
C09
C 10
C00