Azbil DCP31 - 6 - 2 Switching the Basic Display

The“basicdisplaystate”ofthecontrollercollectivelyreferstothedisplaystateoftheprogram
No.display,segmentNo.display,upperdisplay,lowerdisplay,basicindicatorLEDlampsand
eventLEDs.
Eachpressof
DISP
successivelyswitchesthebasicdisplaystate.Operationofotherdisplaysand
LEDsiscarriedoutinthesamewayevenwhensettingupparameters,forexample.However,
switchingby
DISP
isnotpossible.
Thefollowingfigureshowstheconventionsusedfordisplaysinthismanual.
PV
SP
: LED lit
: LED blinking
PV
SP
Program/segment No. Display
Basic indicator LED lamps
Program No. Segment No.
Pattern
tendency
Upper display
Lower display
Event LEDs
Output states of events 1 to 3, time events 1 to 5
Supplementary explanation
In the program operation mode,
READY indicates the currently selected program/segment No.
Displays other than READY indicate the currently operating
program/segment No.
In the constant-value operation mode, nothing is displayed and
this display is blank.
In the program operation mode, the prole is displayed only when the program has been set up.
The prole is not displayed when the program is not set up.
When there is no subsequent segment even if the program is set up, the three LEDs on the right
do not light. In the constant-value operation mode, nothing is displayed and this display is blank.
Prole Display
Current segment Next segment
Falling ramp
Soak
PROFILE
Rising ramp
Rising ramp
Soak
Falling ramp
6-2
Chapter 6. OPERATION
6 - 2 Switching the Basic Display