Azbil DCP31 - Deleting programs

8-17
Chapter 8. PROGRAM SETUP

Display
•Thesettingsarecommontoallsegmentsasthepatternlinkitems
aresettingitemsprovidedforeachprogram.
•Whensetupdata
C71
issetto1,patternlinkitemsonthepro-
grammingmapareskippedandnotdisplayed.

Deleting programs
(1) Inthesettingdisplaystate,movetothepatternitemoftheseg-
mentfromwhichtheprogramistodeletedontheprogramming
map.
Todeleteallthesegmentsofaparticularprogram,movetothe
No.1segment.
(2) Ifyoupress
ENT
,theupperdisplaystartsblinkingtoindicate
startofentrytotheNo.1setup.
(Sofar,theprocedureisthesameasthatforsettingthepattern
item.)
(3) Ifyoupress
FUNC
+
CLR
,thedisplaychangestoconfirmclearing
oftheprogram,and“
CLR.
”isdisplayedblinkingintheupper
display.
(4) Press
ENT
toexecutedeletionoftheprogram.
(5) TheDCP31returnstothesettingdisplaystate,boththeupper
andlowerdisplayschangeto“----”toindicatenosetting.
Link destination program No.
Program No. Segment No.
Pattern
tendency
EV1 to EV3 and T1 to T5 all out
P.L I N