Azbil DCP31 - Setting up events 1 to 3 items

8-8
Chapter 8. PROGRAM SETUP

Display
“----”isdisplayedfortheSPandtimesettingvaluesinnon-set
segments.

Setting up events 1 to 3 items

When event type is PV type event
(1) Inthesettingdisplaystate,movetotheevent1to3itemsofthe
segmenttobesetupontheprogrammingmap.
(2) Ifyoupress
ENT
,theupperdisplaystartsblinkingtoindicate
startofentrytotheNo.1setup.
(3) Press
, , or tosettotheNo.1setupevent
operatingpointsetting.
 Settingrange: -1999to+9999U
0to9999U(incaseofabsolutevaluedeviation
event)
-10.0to+110.0%(incaseofMV,MFBevent)
(4) Whenyoupress
ENT
,blinkingontheupperdisplaystops.
(When
FUNC
+
CLR
arepressed,theupperdisplayreturnsto
“----”andstopsblinking.)

Display (PV type event)
•“----”isdisplayedforthesettingvaluesinnon-setsegments.
•Whensetupdata
C68
issetto1,event1to3itemsonthepro-
grammingmapareskippedandnotdisplayed.
SP
TM
SP1 setting value
Time setting value
Program No. Segment No.
Pattern
tendency
EV1 to EV3 and T1 to T5 all out
Operating point setting value
Program No. Segment No.
Pattern
tendency
LEDs corresponding to EV1 to EV3 lit. T1 to T5 all out