Azbil DCP31 - 3 - 3 Mounting

WARNING
Before removing, mounting, or wiring the DCP31, be sure to turn off the power to
the DCP31 and all connected devices.
Failure to do so might cause electric shock.
Do not disassemble the DCP31. Doing so might cause electric shock.
CAUTION
Use the DCP31 within the operating ranges recommended in the specifications
(temperature, humidity, voltage, vibration, shock, mounting direction, atmo-
sphere, etc.). Failure to do so might cause fire or faulty operation.
Do not block ventilation holes. Doing so might cause fire or faulty operation.
Do not allow lead clippings, chips or water to enter the controller case.
Doing so might cause fire or faulty operation.


Mounting locations
AvoidinstallingtheDCP31inthefollowinglocations:
• Locationsoutsideoftheoperatingtemperaturerange(0to50°C)
andoperatinghumidityrange(10to90%RH)
• Locationssubjecttosulfidegasorotherflammablegases
• Locationssubjecttodustoroilsmoke
• Locationssubjecttothedirectionsunlight,windorrain
• Locationsthatdirectlysubjectthebodytovibrationorimpact
• Locationsunderhigh-voltagelines,nearweldersornearsources
ofelectricalnoise
• Locationsnear(within15m)ofhigh-voltageignitionequipment
suchasboilers
• Locationswheremagneticfieldsaregenerated
• Locationssubjecttoflammableliquidsormoisture
• Outdoors(Indoorsuseonly)
3-3
Chapter 3. MOUNTING
3 - 3 Mounting