Azbil DCP31 - Chapter 8. PROGRAM SETUP; 8 - 1 Program Setup

Chapter 8. PROGRAM SETUP
8 - 1 Program Setup
8-1
ProgramscanbesetupwhentheDCP31isinthebasicdisplaystate.Thisissometimesreferredto
as“programming”inthismanual.
IftheDCP31isnotinthebasicdisplaystate,press
DISP
tosetthecontrollertothebasicdisplay
state.
Programmingcanbecarriedoutmoreeasilyifthedetailsofthesetupareenteredtoaprogram
chartbeforestartingprogramming.

How to enter program setup

Key operation
Press
FUNC
+
PROG
inthebasicdisplaystatetoenterprogramsetup.
Intheprogramsetupstate,thePRGLEDontheconsolelights,and
thedecimalpointsintheprogramNo.displayandsegmentNo.dis-
playlight.However,notethattheDCP31doesnotentertheprogram
setupstateinthefollowingcases:
-Whenintheconstant-valueoperationmode(whenconstant-value
operationdata
M.Ode
settingis1)
-Whenkeylockisactive(variableparameter
LOC
issetto2or4)
Also,thesetupcannotbechangedeveniftheDCP31isinthe
programsetupinthefollowingcase:
-Whentheprogramisprotected(variableparameter
PRtC
isset
to1)

Display start items
WhentheDCP31enterstheprogramsetupstate,displaystartsfrom
theprogramNo.andthesegmentNo.patternitem.

Selecting the program No. to set up
TherearetwowaysofselectingtheprogramNo.tosetup.
-SelectingtheprogramNo.beforeenteringprogramsetup
-SelectingtheprogramNo.afterenteringprogramsetup

Selecting the program No. before entering program setup
ToselecttheprogramNo.press
PROG
or iftheDCP31isinthe
basicdisplaystateintheREADYmode.
Handling Precautions
• The program No. cannot be selected on the DCP31 when
selecting the program No. by external switch inputs.
For details, see 6 - 3 Program Selection (P. 6-8).