Azbil DCP31 - 6 - 3 Program Selection

TheprogramNo.canbeselectedontheconsolewithintherange1to19.

How to select the program No.
Whenthecontrollerisinthe
basicdisplaystateintheprogram
operationREADYmode:
• Eachpressof
PROG
increments
theprogramNo.Thedisplay
revertsto1after19.
• Eachpressof
decrements
theprogramNo.Thedisplay
revertsto19after1.
Handling Precautions
• Both already set or non-set program Nos. can be selected
• The program No. cannot be selected when selecting the program
No. by external switch input.
• The program No. cannot be selected during constant-value
operation.
• Pressing
does not change the program No. when values cur-
rently being entered are displayed in the MANUAL mode.
Program No.1
Program No.2
Program No.3
Program No.4
PROG
PROG
PROG
key
key
key
key
key
key
6-8
Chapter 6. OPERATION
6 - 3 Program Selection