Azbil DCP31 - 8 - 2 Copying Programs

8-20
Chapter 8. PROGRAM SETUP
8 - 2 Copying Programs
TheDCP31canbesetforcopyingprogramsintheprogramoperationREADYmodeinthebasic
displaystate.IftheDCP31isnotinthebasicdisplaystate,press
DISP
.

Operation
(1) SettheDCP31totheprogramoperationREADYmode.
Setvariableparameter
LOC
toeitherof0,1or3,andvariable
parameter
PRTC
to0.
(2) Inthebasicdisplaystate,press
PROG
or toselectthecopy
sourceprogramNo.
However,notethattheprogramNo.cannotbeselectedonthe
consolewhencontrollingtheDCP31byexternalswitchinputs.
Fordetails,see6-3ProgramSelection(page6-7).
(3) Ifyoupress
+
PROG
,“
COPY
”isdisplayedontheupper
display,andthecopydestinationprogramNo.isdisplayedon
thelowerdisplay.
(4) Ifyoupress
or ,currentlynon-setprogramNos.are
displayedblinkinginorderasthecopydestinationprogramNo.
Whentherearenonon-setprogramNos.,“----”isdisplayedon
thelowerdisplay.
(5) Ifyoupress
ENT
,programcopyisexecuted,andthelowerdis-
playstopsblinking.Torepeattheprocedure,carryoutsteps(4)
and(5)again.
(6) Toquitprogramcopy,press
DISP
.

Display
Program No.
Output state of events 1 to 3, time events 1 to 5
Copy destination program No.
C O P Y