Azbil DCP31 - Setting up pattern items

8-7
Chapter 8. PROGRAM SETUP

Display details
Thefollowingfigureshowstheconventionsusedfordisplaysinthis
manual:

Setting up pattern items
(1) Inthesettingdisplaystate,movetothepatternitemoftheseg-
menttobesetupontheprogrammingmap.
(2) Ifyoupress
ENT
,theupperdisplaystartsblinkingtoindicate
startofentrytotheNo.1setup.
(3) Press
, , or tosettotheNo.1setupSPsetting.
 Settingrange: SP1lowertoupperlimit
 (SettheSP1limitinsetupdata
C09
or
C10
.)
(4) Whenyoupress
ENT
,blinkingontheupperdisplaystops.The
lowerdisplaythenstartsblinkingtoindicatestartofentrytothe
No.2setup.
(5) Press
, , or tosettotheNo.2setuptimeset-
ting.
 Settingrange: 0:00to99:59(h:min/min:s)
0.0to599.9(0.1s)
 (Selecteitherofh:minormin:sasthetimeunitinsetupdata
C64
.“:”issubstitutedby“.”asitcannotbedisplayed.)
(6) Whenyoupress
ENT
,blinkingonthelowerdisplaystops.
– –– –
– –– –
: LED lit
Program/Segment No. Display
Basic indicator LED lamps
Program No. Segment No.
Pattern
tendency
Upper display
Lower display
Event LEDs
EV1 to EV3 and T1 to T5 all out
Prole Display
Displays program/segment No. currently being set up.
Decimal point blinks in program setup state.
SP
TM