Azbil DCP31 - Setting up cycle items; Setting up pattern link items

8-16
Chapter 8. PROGRAM SETUP

Setting up cycle items
(1) Inthesettingdisplaystate,movetothecycleitemsonthepro-
grammingmap.
 (Thesettingsarecommontoallsegmentsasthecycleitemsare
settingitemsprovidedforeachprogram.)
(2) Ifyoupress
ENT
,thelowerdisplaystartsblinkingtoindicate
startofentrytotheNo.1setup.
(3) Press
, , or tosettotheNo.1setupcycleset-
ting.
 Settingrange: 0to9999
(4) Whenyoupress
ENT
,blinkingonthelowerdisplaystops.

Display
•Thesettingsarecommontoallsegmentsasthecycleitemsareset-
tingitemsprovidedforeachprogram.
•Whensetupdata
C71
issetto1,cycleitemsontheprogramming
mapareskippedandnotdisplayed.

Setting up pattern link items
(1) Inthesettingdisplaystate,movetothepatternlinkitemsonthe
programmingmap.
(Thesettingsarecommontoallsegmentsasthepatternlink
itemsaresettingitemsprovidedforeachprogram.)
(2) Ifyoupress
ENT
,thelowerdisplaystartsblinkingtoindicate
startofentrytotheNo.1setup.
(3) Press
, , or tosettotheNo.1setuppattern
linksetting.
 Settingrange: 0to19
0:Patternlinkdisabled
1to19:PatternlinkdestinationprogramNo.
(4) Whenyoupress
ENT
,blinkingonthelowerdisplaystops.
Cycle count setting value
Program No. Segment No.
Pattern
tendency
EV1 to EV3 and T1 to T5 all out
C Y C L