Azbil DCP31 - Chapter 7. PARAMETER SETUP; 7 - 1 Parameter Setup

Chapter 7. PARAMETER SETUP
7 - 1 Parameter Setup
7-1
ParameterscanbesetupwhentheDCP31isinthebasicdisplaystate.
IftheDCP31isnotinthebasicdisplaystate,press
DISP
tosetthecontrollertothebasicdisplay
state.

Selecting the setting group in the parameter setup
Parametersetupisdividedintotwostages:settinggroup(major
item)andindividualitem(minoritem).
Ifyoupress
FUNC
+
PARA
inthebasicdisplaystate,thedisplaychang-
estoselectionofsettinggroup(majoritem),thesettinggroupis
displayedontheupperdisplay,andthelowerdisplaygoesout.
Ifyoupress
PARA
, or ,thesettinggroupdisplaychanges
inorder.
Ifyoupress
ENT
whenthesetupgrouptobeselectedisdisplayed,
thedisplaymovestotheindividual(minor)itemlevel.
Thefollowingtableshowsthesettinggroups:
Setting group 1 (major items) selection
Basic Display State
Setting group 2 (major items) selection
Setting group n (major items) selection Individual items
Individual items
Individual items
DISP
key
FUNC
+
PARA
keys
ENT
key
PARA
key
ENT
key
PARA
key
ENT
key
PARA
key
, , , key
, , , key
, , , key
PARA
key
key
key
PARA
key
key
key
PARA
key
key
key