Azbil DCP31 - Chapter 5. FUNCTIONS; 5 - 1 Data


Data types
TheDCP31supportsthefollowingdatatypes:
Forfurtherdetails,
see“Chapter 7. PARAMETER SETUP”and“Chapter 8. PRO-
GRAM SETUP”.
w
Data that can be changed even in
RUN mode
Data Parameters
Program
Data (e.g. event type)
Control parameters of PID sets 1 to 8
Basic data that can be changed only in
READY mode
Linearization table data
Data (e.g. SP, PID) of constant-value
operation
SP and time data
Events 1 to 3 data
Time events 1 to 5 time data
PID set No. data for use in control
G.Soak ON/OFF data
PV START ON/OFF data
Cycle count data
Pattern link destination program No. data
Variable parameters
Event conguration data
PID parameters
Setup data
Table data
Constant-value operation
data
Pattern
Event
Time event
PID set No.
G.Soak
PV start
Cycle
Pattern link
8 alphanumeric characters
(settable from the loader)
Tag
5-1
Chapter 5. FUNCTIONS
5 - 1 Data