Azbil DCP31 - Inserting and deleting segments

8-18
Chapter 8. PROGRAM SETUP

Display
•Intheaboveprocedure,
FUNC
+
CLR
arepressedwhileentering
values(SPsettingvalue)totheNo.1setup.However,theprogram
canalsobedeletedbypressing
FUNC
+
CLR
whileenteringvalues
(timesettingvalue)totheNo.2setup.
•“----”isdisplayedfortheSPandtimesettingvaluesinnon-set
segments.
•Currentlyrunning(RUN,HOLD,FAST,END)programscannot
bedeleted.

Inserting and deleting segments
(1) Inthesettingdisplaystate,movetothepatternitemofthe
segmentwherethesegmentistobeinsertedordeletedonthe
programmingmap.
(2) Ifyoupress
FUNC
+
CLR
,thedisplaychangestoconfirminser-
tionofthesegment,and“
INS.
”isdisplayedblinkinginthe
upperdisplay.
(3) Ifyoupress
,thedisplaychangestoconfirminsertionofthe
segment,and“
INS.
”isdisplayedblinkingintheupperdisplay.
Ifyoupress
,thedisplaychangestoconfirmdeletionofthe
segment,and“
DEL.
”isdisplayedblinkingintheupperdisplay.
(4) Ifyoupress
ENT
while“
INS.
”isdisplayedontheupperdisplay,
thesegmentisinserted.
Ifyoupress
ENT
while“
DEL.
”isdisplayedontheupperdis-
play,thesegmentisdeleted.
(5) TheDCP31returnstothesettingdisplaystate.
Program No. Segment No.
Pattern
tendency
EV1 to EV3 and T1 to T5 all out
C L R.