Azbil DCP31 - Console

2-7
Chapter 2. NAMES & FUNCTIONS OF PARTS
Category Function Key operation
Program setup To clear item setting
(while setting value is blinking)
FUNC
+
CLR
To cancel changing item setting values
(while setting value is blinking)
DISP
To insert/delete segments
FUNC
+
ENT
To change the program No. in ascending order
FUNC
+
PROG
To change the program No. in descending order
FUNC
+
To end program setup (programming)
DISP
Program copy To start program copy
(in basic display state)
+
PROG
To change the copy destination program No.
To execute program copy
(while setting value is blinking)
ENT
To end program copy
DISP
General reset To check general reset
(in basic display state)
FUNC
+
CLR
+
DISP
To execute general reset
ENT
To cancel general reset
DISP
Handling Precautions
• Do not operate the console keys using a sharp-pointed object
such as a propelling pencil or needle. Doing so might damage
the console.