Azbil DCP31 - Page 184

8-6
Chapter 8. PROGRAM SETUP
Shadeditems cannotbemoved.
Segment No.
1 2 . . . . 10 11 12 to 30
Remarks
Program
Items
(1) No.1 setting
(2) No.2 setting
Pattern (1) SP1
1 0 0 1 0 0 0 1 0 0 - - - -
*1
(2) Time
0 . 3 0 3 . 0 0 1 0 . 0 0 - - - -
Event 1 (1) Operating point (ON time)
1 1 0 0 - - - - - - - -
*2
(2) (OFF time)
Event 2 (1) Operating point (ON time)
- - - - 3 0 - - - -
(2) (OFF time)
Event 3 (1) Operating point (ON time)
0 . 0 0 0 . 0 0 0 . 0 0
(2) (OFF time)
0 . 0 1 0 . 0 1 0 . 0 1
Time
event 1
(1) ON time
- - - - 0 . 0 0 - - - -
*3
(2) OFF time
- - - - 1 . 0 0 - - - -
Time
event 2
(1) ON time
- - - - 1 . 0 0 - - - -
(2) OFF time
- - - - 2 . 0 0 - - - -
Time
event 3
(1) ON time
- - - - 2 . 0 0 - - - -
(2) OFF time
- - - - 3 . 0 0 - - - -
Time
event 4
(1) ON time
- - - - - - - - - - - -
(2) OFF time
- - - - - - - - - - - -
Time
event 5
(1) ON time
- - - - - - - - 0 . 0 0
(2) OFF time
- - - - - - - - - - - -
PID set No. (CH1)
1 2 8
*4
G. Soak (CH1)
-
- - - - - - - - - - -
G
.Soak time-out
- - - - - - - - - - - -
PV start
1 1 1
*5
Cycle
0 0 0
Pattern link
0 0 0
*1 The No.10 segment is the nal segment. A non-set segment is shown in the No.11 segment.
*2 As PV type event is selected as the PV type for events 1 and 2, only the No.1 setting can be set up. As
time event is selected as the event type for event 3, the No.1 and No.2 settings can be set up.
*3 As all time events are selected as the event type in the time event, the No.1 and No.2 settings can be
set up.
*4 This can be set as controller functions are selected and PID or ON-OFF control is carried out.
*5 As these are setting items for each program, the display and setting are common for all segments.