Azbil DCP31 - When event type is time event

8-9
Chapter 8. PROGRAM SETUP

When event type is time event
(1) Inthesettingdisplaystate,movetotheevent1to3itemsofthe
segmenttobesetupontheprogrammingmap.
(2) Ifyoupress
ENT
,theupperdisplaystartsblinkingtoindicate
startofentrytotheNo.1setup.
(3) Press
, , or tosettotheNo.1setupONtime
setting.
 Settingrange: 0:00to99:59(h:min/min:s)
0.0to599.9(0.1s)
 (Selecteitherofh:minormin:sasthetimeunitinsetupdata
C64
.“:”issubstitutedby“.”asitcannotbedisplayed.)
(4) Whenyoupress
ENT
,blinkingontheupperdisplaystops.The
lowerdisplaythenstartsblinkingtoindicatestartofentrytothe
No.2setup.
 ( W h e n 
FUNC
+
CLR
arepressed,theupperandlowerdisplays
bothreturnto“----”andblinkingstops.)
(5) Press
, , or tosettotheNo.2setupONtime
setting.
 Settingrange: ONtimesetting+0:01to99:59(h:min/min:s)
ONtimesetting+0.1to599.9(0.1s)
(6) Whenyoupress
ENT
,blinkingontheupperdisplaystops.
 ( W h e n 
FUNC
+
CLR
arepressed,theupperdisplayreturnsto
“----”andstopsblinking.)

Display (time event)
•“----”isdisplayedforthesettingvaluesinnon-setsegments.
•Whensetupdata
C68
issetto1,event1to3itemsonthepro-
grammingmapareallskippedandnotdisplayed.
•WhentheeventtypeissettotimeeventandtheONtimeissetto
99:59,“----”isdisplayedfortheONtimeandthedisplaydoesnot
blink.Inthiscase,theOFFtimecannotbeset.
•WhentheeventtypeissettotimeeventandtheONtimeisset
higherthanthetimesettingofthepatternitem,eventoutputat
thatsegmentisOFF.However,notethateventoutputisONwhen
ON time setting value
OFF time setting value
Program No. Segment No.
Pattern
tendency
LEDs corresponding to EV1 to EV3 lit. T1 to T5 all out