7. Advanced
A Edit dialog box is displayed and the left side soft edge zone is selected. The default level is the level 1.
Image 7-194
2. Use the arrows to select a point to be displaced
3. Press ENTER to go to the Edit mode
4. Use the arrows to select the desired field
5. Press ENTER to edit the field
The edit field is put in the edit mode
6. Use the arrows or the digits to fill in the desired x position of the selected point (in this case the left top point of level 1)
7. Press ENTER to confirm
The selected point is displaced to the new position (x=100 ; Y=0).
Image 7-195
8. Press BACK to exit
158
R59770324 SIM 5W 22/12/2011
Downloaded From projector-manual.com Barco Manuals
To Next Page
Loading...
