３‐５
10. USB (Port 1)
This is for a USB connection. It is used for uploading and downloading design data and also for
updating the System software.
11. USB (Port 2)
This is a secondary USB connection. It is used for uploading and downloading design data and
also for updating the System software.
12. LAN
This is for a LAN connection, for connecting the machine to a machine network. Optional
Networking software is required to use this connection.
13. COM
This is for a COM connection for downloading designs from a PC to the machine. This operation
requires PC software that can transfer designs by COM connection.
14. DRIVER
Connector to connect the Automat to the X-Series Driver Unit.
15. AC100V
Power inlet for AC100V
To Next Page
Loading...