Manual setting the Length of Section 2
⦁
touch the «man»-icon
►
sew first section
⦁
use «Quick reverse»-button to set the length of
section 2
►
the third section is automatically sewn and the
sewing computer stops
►
the length is not programmed and must be reset
each time a new tapered pattern is started
Balance
To balance forward and reverse stitches.
Balance BERNINA Dual Transport
Adjusting the feed of the upper fabric layer.
Backstepping
The last 200 needle penetrations of a stitch pattern are
retraced, i.e. sewn backwards.
Personal memory permanent
⦁
select a stitch pattern and alter e.g. stitch length or
stitch width
⦁
touch the icon
►
the altered stitch pattern is saved
Distorting the stitch pattern
⦁
touch the upper «+» or «-» icon or turn the stitch
width knob to the right or to the left
►
the stitch pattern will be distorted in 0.01 mm steps
to the right or to the left
⦁
touch the lower «+» or «-» icon or turn the stitch
length knob to the right or to the left
►
the stitch pattern will be distorted in 0.01 mm steps
forwards or backwards
Reset
⦁
touch the icon
►
any alterations of the selected stitch pattern are
reset to the original basic setting
Close
⦁
touch the «i»- or «Close»-icon
►
the Display showing the functions is closed
►
the tapering patterns appear
To Next Page
Loading...
