Removing the Bobbin
Threading lower thread
⦁
pull the thread to the right into slit 1 then left under the spring
Thread cutter lower thread
⦁
pull thread over thread cutter 2 and cut
Removing the Bobbin
⦁
open bobbin cover
►
the hook system swings to the front
⦁
push the latch in the center of the bobbin to the left
⦁
the bobbin pops out and can be removed
Inserting the Bobbin
⦁
with bobbin markings facing the front, place the bobbin into the hook and
push until it clicks into place
2
1
ATTENTION!
Only remove the bobbin if the hook is at the end position
(threading position).
Check the threading path
⦁
after threading the hook, hold the mirror under the swung-out hook unit as
shown in the pictures below
►
position of bobbin thread when threaded for sewing
⦁
close the bobbin cover slowly
►
the hook swings back to the rear
To Next Page
