Bernina 880 - Changing the Needle; Removing the Needle; Inserting the Needle

25
Sewing preparation
1
Removing the needle
⦁
raise the needle
⦁
remove or lower presser foot (see page 27, 39)
⦁
turn power switch to «0» (off)
⦁
loosen the needle clamp screw 1 using the gray screwdriver
⦁
pull the needle down to remove
Inserting the needle
⦁
flat side of needle to the back
⦁
insert the needle with the mulitfunction tool as far as it will go
⦁
tighten needle clamp 1 using the gray screwdriver
Changing the needle
1
034791.51.04_2014-02_Manual_B880_EN