Bernina 880 - Programming the Foot Control; Programming Securing Stitches; Automatic Thread Cutter; Raising the Presser Foot

56
Setup-Program
Standard = icon 1 is activated.
⦁
back heel kick in the foot control
►
the needle is raised or lowered
⦁
touch icon 2
Programming securing stitches
►
when the icon 3 is activated, the number and type of securing stitches can
be programmed via back-heel-kick on the foot control
►
Standard = four securing stitches at the place
⦁
touch icon 4 for securing stitches forward
⦁
using the «+»/«-»-icons two up to six securing stitches can be programmed
Automatic thread cutter
►
with icon 5 activated, the upper and the lower thread are cut automatically
by back heel kick
►
is the icon deactivated, the threads cannot be cut
Raising the presser foot
►
with the icon 6 activated, the presser foot is raised by back heel kicking
►
is the icon deactivated, the presser foot remains down
1
Programming the foot control
⦁
touch the «Foot control»-icon
2
43
5 6
034791.51.04_2014-02_Manual_B880_EN