!
26 ATOMLAB 500 DOSE CALIBRATOR
Following the power-up system test, a screen is displayed showing the components and
detector status. If all items pass, “Pass” is displayed at the completion of the test. Should any
aspect of the self-test fail, “Fail” is displayed, along with an accompanying error code and
optional description of the problem.
Once the system check is completed, touch <Print> to generate a printout of the system test
results and/or touch <Home> to advance to the Atomlab 500 Home screen.
Save The Packing Material
Now that you have set up your Atomlab dose calibrator, and everything is intact and functioning
properly, take a few moments to repack the packing material. This material was especially
designed for safe shipment of the Atomlab dose calibrator and should be considered part of the
instrument. Place the shipping material in the appropriate boxes and put the boxes back into the
shipping carton. Label the carton and store it in a safe, out-of-the-way location. If you ever need to
return your dose calibrator for updates, calibration, or repair, use the original shipping carton,
boxes, and shipping material.
Maintenance
General Cleaning Instructions
As required, wipe down the exterior of the unit using a soft rag slightly dampened with alcohol.
Use neutral detergent or isopropyl alcohol on a clean soft cloth to clean the panel surface. Do not
use any kind of chemical solvent, acidic or alkali solution.
NOTE: To properly maintain your Atomlab Dose Calibrator, quality assurance should be
performed as suggested in Appendix J: Quality Assurance Testing of Atomlab Dose
Calibrators.
Password Protection
There are several program setups that require the use of a password for access to make
changes. The default password is: 123, followed by <Enter>.
If you need to change the password, contact Biodex Customer Service at 800-224-6339.
To Next Page
Loading...
