P1 Patient Monitor User’s Manual
11-2
(3) TEMP alarm limits: If TEMP alarm is turned off, the alarm closing icon is displayed
here.
(4) TEMP value
(5) TEMP Difference (T): TEMP Difference between two temperature sites. It displays
only when T is switched on.
11.4. Preparing for TEMP Monitoring
Please follow these steps to prepare TEMP measurement:
1. According to the type of patient and the measurement site, select the
appropriate temperature probe.
2. Insert the probe or extension cable into the temperature probe connector. If a
disposable probe is used, connect the probe and extension cable.
3. Refer to the instructions for using the probe and connect the probe to the
patient.
11.5. TEMP Settings
11.5.1. Setting TEMP Alarm
To set the temperature alarm, follow this procedure:
1. Select the TEMP parameter area to enter the 【TEMP】menu.
2. Select【Alarm】submenu.
3. If the alarm setting is protected by password, enter the password. For detail,
please refer to 7.7.2 Changing Alarm Setup Protection Mode.
4. Set alarms as needed.
11.5.2. Setting TEMP Label
Select the temperature label according to the measurement site. To do so, follow this
procedure：
1. Select the TEMP parameter area to enter the【TEMP】menu.
2. Select【Setup】submenu.
3. Set the TEMP label name according to the measurement site.
To Next Page
Loading...