Biolight Meditech P1 - Using the Timer

P1 Patient Monitor User’s Manual
3-15 

3.6.7.2. Exiting the Outdoor Mode
The methods of exiting the outdoor mode are as below:
1. Select 【Main Menu】 quick key.
2. Select 【Exit Outdoor Mode】 on the 【Display】 column.
When the monitor plugged into another monitor as a parameter module, it will exit the
outdoor mode automatically.
3.7. Using the Timer
The monitor provides timer function, which can display up to four timers at the same
time. You can set each timer separately, which prompts when the set time arrives.
3.7.1. Displaying Timer
To display a timer, follow this procedure:
1. Access【Screen Layout】in either of the following ways:
 Select【Screen Setup】quick keySelect【Screen Layout】submenu.
 Select【Main Menu】quick keyfrom the【Display】column to select
【Screen Layout】.
2. Click the parameter area where you want to display the timer, select 【Timer】
 select【Timer1】,【Timer2】,【Timer3】,【Timer4】.
3.7.2. Controlling the Timer
The timer provides the following controls:
【Start】:Start the timer.
【Pause】:
Pause the timer.
【Resume】: Resume the timer.
【Reset】:
Clear the current timing results and reset the timer.
WARNING：
 Do not use the timers to schedule critical patient-related tasks.