Biolight Meditech P1 - Operation Mode

P1 Patient Monitor User’s Manual
3-9 

1. Enter【Screen Layout】interface in one of the following ways:
 Select 【Screen Setup】 quick keyselect 【Screen Layout】s ubmenu.
 Select 【 Main Menu 】 quick keyfrom 【Display】 column to select
【Screen Layout】.
2. Select a parameter area or waveform. From the pop-up parameter list to select
the elements needed to display in the area. The selected parameters and
waveforms are displayed according to the set position. The parameters and
waveforms that are not selected will not be displayed on the interface.
NOTE
：
The first line of the parameter area and the waveform area always
displays the ECG parameters and the first ECG waveform.
WARNING：
 The parameters of the 【Screen Layout】 are not assigned to the display area,
which will not be displayed on the monitor interface and relevant alarms for
this parameter will still be provided
3.5.3. Setting the Parameter
Each parameter has an independent setting menu, through which alarm and
parameter setting can be modified. You can enter the Parameter Setting Menu in the
following ways:
 Select the parameter area or waveform area of a parameter
 Select 【 Main Menu 】 quick key, from 【 Parameter 】 column to selec t
【 Setup 】， and then select corresponding parameter.
3.6. Operation Mode
3.6.1. Monitor Mode
Monitor mode is the most common clinical working mode used to monitor patient.