P1 Patient Monitor User’s Manual
19-1
Chapter 19 Maintenance and Cleaning
Use only the disinfectants, cleaners and methods listed in this section to clean or
disinfect the monitor, plug-in modules, docking station, transfer handle and some
accessories. We do not provide any guarantee for damages or accidents caused by the use
of other materials or methods.
Our company is not responsible for the effectiveness of the listed chemicals or
methods as a means of controlling infection. Please consult the hospital’s Infection
Control Officer or Epidemiologist.
19.1. Introduction
Keep your monitor, plug-in modules, docking station, transfer handle and some
accessories free of the dust and dirt. To avoid damage to the equipment, follow these
rules:
Please dilute the detergent and disinfectant according to the manufacturer’s
instructions, or use as low a concentration as possible.
Do not immerse the monitor in liquid.
Do not pour liquid on the monitor or accessories.
Do not allow liquid to enter the cabinet.
Abrasive materials (such as steel wool or silver polishing agent) and any strong
solvent (such as acetone or detergent containing acetone) as well as liquids with
strong conductivity (such as physiological saline) shall not be used.
Please do not clean or disinfect the equipment when it is running or when it is
exposed to direct sunlight.
Ensure that all parts of the equipment are completely dry after cleaning and
disinfection.
WARNING:
Disconnect the power cord from the socket before cleaning the monitor.
To Next Page
Loading...