Biolight Meditech P1 - Spo Screen

P1 Patient Monitor User’s Manual
6-9

> Down to the next second
>> Down to the next page
>>| Down to the last page
 You can set the speed of the frozen waveform as needed.
6.6.3. Releasing Freezing
Under freezing condition, you can select button in the upper right corner of the
freezing menu to release the freezing condition.
6.7. SpO
2
Screen
For neonatal patients, if you only care about the patient’s SpO
2
and PR, you can
use the SpO
2
Screen. The SpO
2
Screen uses large fonts to display the data of SpO
2
related parameters, and real-time temperature and NIBP values.
NOTE:
 The SpO
2
Screen is only applicable to neonates.
6.7.1. Entering the SpO
2
Screen
Choose any of the following methods to enter the SpO
2
Screen:
 Use two fingers to slide the touch screen left and right to switch to the SpO
2
Screen.
 Select 【Screen Setup】 quick key → select 【Screen Select】 submenu
→ select 【SpO
2
Screen】.
 Select 【Main Menu】quick keyfrom【Display】column to select【Screen
Select】→ select 【SpO
2
Screen】.
6.7.2. SpO
2
Screen Display
The figure below is a schematic diagram of the SpO
2
Screen. The graphics